Material Handling Energy UNIT 2
This energy unit capabilities electrical power up gravity down circuit. Activate the start out solenoid to start out the motor to lift the machine. The lowing movement is activated by the solenoid valve with all the decreasing velocity controlled by the stress compensated movement handle valve. Merchandise of this series is usually widely utilized in the sector of logistic gadgets including fork lift, mini lift table, and so on.
1. The duty of this power unit is S3,i.e.,30 seconds on and 270 senconds off.
two. Clean all of the hydraulic parts concerned prior to mounting the energy unit.
three. Viscosity in the hydraulic oil shoud be 15~46 cst,which really should also be clean and free of charge of impurities, N46 hydraulic oil is proposed .
four. Oil modifying is required immediately after the first one hundred operation hrs,afterwards the moment each and every 3000 hrs.
5. The power unit must be mounted horizontally.
Materials Handling Energy UNIT 1
This power unit is developed for that fork lift sector, consisting of very effective gear pump, DC motor, guide increase and lower valve, tank, ect. The up and down motion are controlled by the lever of the manual release valve, that is outfitted with an electric switch to activate the motor. The lowing speed is controlled from the pressure compensated movement control valve.
one. The duty of this power unit is S3, i.e. 30 seconds on and 270 senconds off.
two. Clean every one of the hydraulic parts concerned ahead of set up of the electrical power unit.
three. Viscosity in the hydraulic oil shoud be 15~46 cst, which need to also be clean and free of impurities, N46 hydraulic oil is advised .
4. Oil shifting is needed immediately after the first 100 operation hours, afterwards as soon as just about every 3000 hrs.
five. The power unit proven is intended to be mounted horizontally.