Capacity
All power take-offs are particularly designed for driving hydraulic pumps to SAE J744C series ‘B’ specification with splined insight shaft and either two-bolt or four-bolt fixing. The maximum power which can be transmitted is 22 KW (29.5 bhp) per 1000 rev/min engine speed; this equates to a torque of 209 Nm (155 Ibf.ft. – 21.33 kgm.).For PRM1000 the clutched power take-off provides pump rotation exactly like the engine, where as the direct drive power take-off for the PRM500 and PRM750 will give opposite rotation. Power to the pump is not affected by the standard utilization of the gearbox for propulsion duties. All ancillary power circuits driven by PRM power take-offs ought to be designed relative to the recommendations of the hydraulic products manufacturer, and should be correctly safeguarded against overloading.
Installation
PRM power take-off products fit on the trunk face of the primary gearcase and so are driven by the insight shaft; consequently they may be operated all the time whilst the engine is running, The energy take-off replaces the finish cover which is generally installed and performs the features of the finish cover by sealing the gearbox against loss of oil and properly positions the input shaft rear bearing. Power take-off systems provide the link between the gearbox and the hydraulic pump.
Direct Drive Power Take-Off
On the PRM500 and PRM 750 the immediate drive power take-off is certainly driven directly from the gearbox input shaft; consequently it’ll operate 
all the time when the engine can be working, and since there is no clutch for disengagement of the hydraulic pump, provision must be manufactured in the auxiliary hydraulics circuits for pressure by-move to the reservoir when capacity to the pump is not needed. A set of 1:1 ratio gears, providing sufficient offset between your gearbox result shaft and the centreline of the energy take-off to make sure there is enough clearance between your hydraulic pump and propeller shaft coupling.
Specifications
Ever-Power PTO Shaft
Series 6
1-3/8 inch 6-spline tractor end yoke and a 1-3/8 inch 6-spline FD2 clutch on the implement end
FD2 clutch
Collapsed length: 47 in.
Extended length: 60 in.
62 HP at 540 RPM
98 HP at 1000 RPM
FD2 clutch attaches with one bolt that fits a groove on insight shaft of rotary mower
Visit our site for more information about pto gearbox.