XLEDPlanetary cycloid reducer installation
1. InXLED planetary cycloid reducerWhen installing couplings, belt pulleys, sprocket and other coupling parts on the output shaft of the reducer, direct hammering is not allowed. Because the output shaft structure of the reducer cannot withstand the axial hammering force, it can be screwed in with the screw hole at the shaft end. The screw is pressed into the coupling piece.
2. The shaft diameters of the output shaft and the input shaft are matched with GB1568-79.
3. Planet XCycloid reducerThe eyebolts above are only for lifting the reducer.
4. When the reducer is installed on the foundation, the elevation of the installation center line of the reducer, the levelness and the relevant dimensions of the connected parts should be calibrated.The concentricity of the calibrated moving shaft should not exceed the allowable range of the coupling.
5. When calibrating the X planetary cycloidal pinwheel reducer, it can be carried out with steel spacers or cast iron spacers. The height of the spacers is not more than three, and it can also be carried out with a contract iron, but the reducer should be replaced with a flat spacer after calibration Piece.
6. The configuration of the cushion block should avoid causing deformation of the machine body, and should be arranged symmetrically on both sides of the foundation bolts, and the mutual distance can be sufficient to allow the water slurry to circulate freely during irrigation.
7. The irrigation of cement slurry should be dense, without bubbles, voids and other defects.Reduction ratio: the ratio of input speed to output speed.Number of stages: the number of sets of planetary gears.Generally, it can reach level three, and the efficiency will be reduced.Full load efficiency: In the case of full load (fault stop output torque), the transmission efficiency of the reducer.Working life: The accumulative working time of the reducer under rated load and rated input speed.Rated torque: the torque for long-term operation allowed by the rated life.When the output speed is 100 rpm, the life of the reducer is the average life. When this value is exceeded, the average life of the reducer will be reduced.The reducer malfunctions when the output torque exceeds twice.